Mobility, Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
Push the card into the socket slightly until it ‘clicks’ then release pressure. The card
can now be pulled from the socket.
To insert a card, align it with the socket with the contacts facing PCB and closest to
the socket. Slide it into the socket and apply slight pressure until it ‘clicks’. The card
is now located correctly. The photos below show the correct orientation for the card.
Note: It is important that the card is not write protected. The ‘lock’ switch must be in
the position shown in the diagram below:
SD card Write Enable switch position
SD Card Orientation
SD card partially inserted - incorrect ✓ SD card fully inserted - correct
To Next Page
Loading...
