Mobility, Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
Figure 46 – ST950 ELV Rack for fitting in Alternative Cabinets (rear)
In a ‘cuckoo’ rack, the RJ45 serial cables between the CPU Card and the LSLS
cards are replaced by 10-way ribbon cables connected in a daisy-chain between
the CPU Card and the LSLS cards across the front of the rack.
The address of each LSLS card is set by connecting the appropriate ADDRESS pin
to ADDRESS RET on the rear connector as shown in Figure 47
To Next Page
Loading...
