4.6 Leaving commissioning
When you leave the COMMIS (commissioning) menu by pressing the ESC button,
the controller displays the following information to indicate that the plant will be
started:
User information
COMMIS
PASS
Pressing the OK button produces the following results:
Plant is started
• Application starts:
– All sensors are checked, and
– Existing sensors are marked for future fault status messages
• The display changes to the next higher menu level and the first menu symbol
COMMIS blinks:
PASS
PARA
COMMIS
SET
INFO
Now press the ESC button twice.
The controller will display an Info page like the following if it is in normal mode:
Exit
PASS
29 / 174
Siemens Universal Controllers RLU2… CE1P3101en
Building Technologies Commissioning 29.08.2008
To Next Page
Loading...
