SIGLENT SSA3021X User Manual

SIGLENT
SSA3000X User Manual 7
For fear of damaging your hearing, please turn the volume down to zero and
gradually turn the volume up after putting on the earphone.
4. TG SOURCE
The TG SOURCE can be connected to a receiver through a cable with an N-male connector.
CAUTION
To avoid damage to the tracking generator, the reverse DC voltage cannot
exceed 50 V
5. RF INPUT
The RF INPUT can be connected to a DUT through a cable with an N-male connector.
CAUTION
To avoid damage to the instrument, for the signal input from the RF input
terminal, the DC voltage component and the maximum continuous power of
the AC (RF) signal component cannot exceed 50 V and +30 dBm
respectively.
1.5 Rear Panel
Figure 1-10 Rear Panel
1. Handle
Pull up the handle vertically for easy carrying of the instrument. When you do not need the handle,
press it down.

SIGLENT SSA3021X Specifications

General

Frequency Range	9 kHz to 2.1 GHz
Resolution Bandwidth (RBW)	1 Hz to 1 MHz
Sweep Time	1 ms to 1000 s
Input Impedance	50 Ω
Input VSWR	< 1.5
Maximum Input Level	+30 dBm
Tracking Generator	Optional
Displayed Average Noise Level (DANL)	-161 dBm/Hz
Interfaces	USB Host, USB Device, LAN, GPIB (optional)
Display Resolution	1024 points
Power Requirements	100 V - 240 V AC, 50 Hz/60 Hz
Phase Noise	-98 dBc/Hz @ 10 kHz offset (1 GHz carrier)