SIGLENT
SSA3000X User Manual 4
Set the parameters of frequency, and Peak→CF, CF→Step.
Set the parameters of span, and X-scale (Log-Linear) setup.
Set the parameters of amplitude, including Ref Level, Attenuator, Preamp, etc;
and Correction setup.
Scan the full span rapidly and move the biggest signal to center freq, and
automatically sets the optimal parameters according to the signal.
Set the parameters of RBW and VBW, Average Type (Log power, Power,
Voltage), and Filter Type (-3 dB Gauss\ -6 dB EMI).
Select Trace, Trace setup and Trace math.
Set the parameters of sweep, and EMI QPD Dwell Time.
Select the Detector type for each trace independently.
Select triggers in Free Trigger, Video Trigger and External Trigger.
Set the parameters of tracking generator. Including TG Level, TG level offset,
Normalization setup. The backlight LED is on when TG source is on.
Set the demodulation parameters of the AM and FM for audio listening
Set the Markers and Marker Table
Set other system parameters on the basis of the current marker value.
Special functions of the marker such as noise marker, N dB bandwidth
measurement and frequency counter.
Search for the peak signal, peak search configuration and peak table.
In spectrum analyzer mode, select the Advanced Measurement function
In non spectrum analyzer mode, select corresponding settings.
Set the measurement parameters.
Set the system parameters
Select the working mode between spectrum analyzer and other modes.
Set the display parameters.
Use the file system and files
Sets the system to certain status
Set the parameters of some functions between auto and manual.
Turn on the built-in help
1.4.2 Front Panel Key Backlight
The on/off state and the color of the backlights of some keys at the front panel indicate the working
To Next Page
Loading...
