SIGLENT SSA3021X User Manual

SIGLENT
SSA3000X User Manual 28
2. Max Hold
Retains the maximum level for each trace point of the selected trace. Updates the data if a new
maximum level is detected in successive sweeps.
3. Min Hold
Display the minimum from multiple sweeps for each point of the trace and update the data if a new
minimum is generated in successive sweeps.
4. View
Holds and displays the amplitude data of the selected trace. The trace data is not updated as the
analyzer sweeps.
5. Bank
Disable the trace display and all measurements of this trace.
2.2.2.3 Average Times
Set the number of averages of the selected trace. More averages can reduce the noise and the
influence of other random signals; thus highlighting the stable signal characteristics. The larger the
number of averages is, the smoother the trace will be.
Table 2-14 Average Times
Parameter
Explanation
Default
100
Range
1 ~ 999
Unit
N/A
Knob Step
1
Direction Key Step
5
2.2.2.4 Math
Set the computational method of the math trace.
2.2.2.5 Variable X, Y
Variable X, Y can choose trace A, B, C.
2.2.2.6 Output Z
The result Z will show on screen in trace A, B, C as you choose.

SIGLENT SSA3021X Specifications

General

Frequency Range	9 kHz to 2.1 GHz
Resolution Bandwidth (RBW)	1 Hz to 1 MHz
Sweep Time	1 ms to 1000 s
Input Impedance	50 Ω
Input VSWR	< 1.5
Maximum Input Level	+30 dBm
Tracking Generator	Optional
Displayed Average Noise Level (DANL)	-161 dBm/Hz
Interfaces	USB Host, USB Device, LAN, GPIB (optional)
Display Resolution	1024 points
Power Requirements	100 V - 240 V AC, 50 Hz/60 Hz
Phase Noise	-98 dBc/Hz @ 10 kHz offset (1 GHz carrier)