Sigma 6-16S - 6.3.2.11 Changing the Contrast; Program Mode

Laboratory Centrifuge Sigma 6-16S
6 Using the centrifuge
52 / 91
Version 07/2012, Rev. 1.22 of 08/05/2020 • sb
Translation of the original operating manual, part no. 0702002
6.3.2.11 Changing the contrast
To change the contrast:
• Press and hold the stop button and turn the function knob one notch to
the left. A dialog box will be displayed once the stop button is released.
• Adjust the contrast of the centrifuge display and confirm the change.
Fig. 25: Dialog box for changing the contrast
→
6.3.3 Program mode
A program contains all of the data that are required for a centrifuge run.
Certain sedimentation results can be repeated under identical conditions.
Programs can be loaded, executed, edited, and deleted when the
centrifuge is at a standstill.
A maximum of 60 programs can be stored under the numbers 1 - 60.
"--" means that the values that are currently set are not a stored program.
The programs can be protected against unauthorised use, modification, or
deletion with the aid of a code (see chapter 6.3.2.7 - "Parameters menu").
Stored programs are listed in the "Process library" menu .