Sigma 6-16S - Automatic Program Rotation

Laboratory Centrifuge Sigma 6-16S
6 Using the centrifuge
Version 07/2012, Rev. 1.22 of 08/05/2020 • sb
55 / 91
Translation of the original operating manual, part no. 0702002
→
6.3.3.5 Automatic program rotation
With the automatic program rotation, several programs can be executed
directly one after the other.
• Activate the "Program rotation" function in the "Setup" menu .
Fig. 29: Program rotation function
When a program is loaded while the program rotation function is active, this
program will be used as the start program for the rotation. After the
completion of the program, the next program on the program list will be
loaded automatically. The rotation continues up to the next empty storage
location and then restarts from the beginning (see the following illustration).
Example 1: Loading of Test04
Rotation: Test04, Test05, Test06, Test04,...
Example 2: Loading of Test05
Rotation: Test05, Test06, Test05,...
Fig. 30: Automatic program rotation
While the program rotation function is active, the arrow " " is displayed in
the program line in the "Standard" menu.