123
The shutter does not release.
The camera is busy writing to the card.
Ź Please wait until the card busy light goes off.
Card is full.
Ź Insert a new card or delete unwanted images. (P.91 - 93)
Autofocus does not operate.
Focusing mode is set to MF.
Ź Change the focusing mode by pressing the Focus mode button.
(P. 4 9 )
The camera has turned off automatically.
Auto Power Off is activated.
Ź The Auto Power Off function is set in order to conserve battery
power. If it is inconvenient, please set the Auto Power Off to “Off”.
(P. 11 4 )
Cannot shoot or store images.
Card is full
Ź Insert a new card or delete unwanted images. (P.91 - 93)
Battery is exhausted.
Ź Replace the battery. (P.18 - 22)
The write protection switch is in the ‘LOCK’ position.
Ź Please unlock the write protection switch on the card. (P. 1 0 )
Image data on the card is corrupted.
Ź If important data remains in the card after transferring it to your PC,
please format the card. (P. 4 2 )
Difficulty seeing the images on the color LCD monitor.
Dust or dirt has adhered to the color LCD monitor.
Ź Clean the color LCD monitor with a blower or eyeglass cloth.
(P. 11 9 )
The color LCD monitor is worn out.
Ź Please consult the retailer from which you purchased the camera
or contact the nearest Sigma Service Center.
To Next Page
Loading...
