Instruction Manual LabScat 2 Packaging/Transport/Returning
52 12112E/2
13 Packaging/Transport/Returning
Injuries to persons caused by dangerous samples in the returned instrument.
Instruments that have come into contact with dangerous samples may not be sent to be re-
paired without information regarding the concerned sample.
Detailed information about the samples must be received by SIGRIST-PHOTOMETER so that
relevant precautionary measures can be taken when unpacking.
Damages to the water bath can occur during transportation by air.
Due to the low outer pressure during air transportation, the glued points on the water bath
may be subjected to excess load and thus damaged.
It is thus absolutely essential to unscrew the cover of the desiccant container slightly
when transporting by air.
The original packaging of the photometer and its peripheral devices should be used for
packaging when possible. If the original packaging is no longer available, note the following
information:
Before packaging, close the openings of the photometer with adhesive tape or plugs so
that no packaging materials can enter the instrument.
The photometer contains optical and electronic components. Make sure that the pack-
aging protects the instrument from being damaged by impact during transport.
All peripheral devices and accessory parts must be packaged separately and marked with
serial numbers (Section 2.2). This prevents confusion and mix-ups later while also mak-
ing it easier to identify parts.
When sending for repairs, ensure that the complete instrument including the checking
unit is sent.
Fill in the repair note and attach to the inside of the packaging.
When packaged in the way described above, the instruments can be transported by the usu-
al shipping methods and in all positions.
To Next Page
Loading...
Need help?
General
