SIGRIST TurBiScat PM 40 User Manual

60 pages

To Next Page

TurBiScat PM 40

sigrist.com

Operating Manual

Table of Contents3
About this Document6
Purpose of the Instruction Manual6
Storage of the Instruction Manual6
Target Group6
Conformity6
Representation Conventions6
Your Safety8
Intended Use8
Restrictions on Use8
Foreseeable Misuse8
Warnings8
Residual Risks9
Device Data10
General View10
Turbiscat PM 40 with Display10
Turbiscat PM 40 with Sidis AD 4010
Nameplate11
Scope of Supply and Accessory Parts11
Mounting12
General Information on Mounting12
Mounting Position of the Photometer12
Fitting in VARINLINE Connector12
Mounting Sidis AD 4013
Wall Mounting13
Rotate Mounting Plate13
Electrical Installation14
Determine Communication Module14
Photometer Connection14
Eg_Io14
Eg_Poe16
Eg_Profibus16
Eg_Profinet17
Operation18
Display18
SIGRIST-Webinterface18
Commissioning19
Settings21
Displays on the Photometer21
Sigrist-Webinterface27
Homepage27
First Steps27
Simple Configuration Mode28
Menu: Configuration28
Menu: Simulation30
Menu: Recalibration31
Menu: History31
Menu: System Info31
Advanced Configuration Mode33
Menu: WLAN35
Menu Configuration36
Menu: Display37
Menu: Simulation38
Menu: Recalibration38
Menu: Sensor Check38
Menu: Logger38
Menu: System39
Menu: Meas. Channels39
Menu: Math. Channels40
Menu: Measuring Info41
Menu: History41
Menu: System Info41
Logger Diagram41
Field Bus42
General Requirements42
Fault Codes42
Modbus RTU/ TCP42
Servicing45
Maintenance Schedule45
Replace Desiccant45
Clean Sensor Head46
Calibration Check46
Overview of Control Unit46
Cleaning the Control Unit47
Carry out Calibration Check with Control Unit47
Replace Seals (VARINLINE Connection)49
Spare Parts49
Troubleshooting50
Isolate Faults50
Warning / (Prio) Error Messages51
Warning Messages51
Fault Messages52
Prio Fault Messages53
Specification Sheet54
Turbiscat PM 4054
General54
Sidis AD 4055
Communication Modules56

Other manuals for SIGRIST TurBiScat PM 40

Brief Instructions196 pages

Questions and Answers:

C
Cynthia TylerAug 6, 2025
What to do if measured value seems wrong in SIGRIST Measuring Instruments?
- B
  bacevedoAug 6, 2025
  If the measured value appears incorrect, verify the operating conditions of the sample medium. Also, check the calibration and mounting of the device. Confirm that servicing has been performed correctly and perform a sensor check.
K
Kimberly RamirezAug 20, 2025
How to fix no display on SIGRIST TurBiScat PM 40?
- K
  kathleenpayneAug 21, 2025
  If there is no display, check the service voltage.