Silca Matrix Evo - Default Chapter; Table of Contents

To Next Page

To Previous Page

INDICE

USE OF THE MANUAL ....................................................................................................................... 1

GLOSSARY SYMBOLS-TERMINOLOGY ........................................................................................... 2

GENERAL WARNINGS ....................................................................................................................... 4

1 MACHINE DESCRIPTION ....................................................................................................................5

2 WORKING PARTS - Matrix PRO ..........................................................................................................6

3 WORKING PARTS - Matrix EVO ..........................................................................................................7

4 ACCESSORIES PROVIDED ................................................................................................................8

4.1 Technical data ...................................................................................................................................8

5 ELECTRIC DIAGRAM .........................................................................................................................9

6 HANDLING .........................................................................................................................................10

6.1 Packing ........................................................................................................................................... 10

6.2 Transport ........................................................................................................................................10

6.3 Unpacking.......................................................................................................................................10

6.4 Handling the machine .....................................................................................................................10

7 MACHINE INSTALLATION AND PREPARATION ..............................................................................11

7.1 Checking for damage ..................................................................................................................... 11

7.2 Environmental conditions ............................................................................................................... 11

7.3 Positioning ...................................................................................................................................... 11

7.4 Safety devices ................................................................................................................................ 11

7.5 Work station description .................................................................................................................12

7.6 Starting the key-cutting machine ....................................................................................................13

7.6.1 Starting the motor .......................................................................................................................... 13

7.6.2 Cutter motor on warning light ........................................................................................................ 13

7.6.3 Led lamp (matrix pro version) ........................................................................................................ 13

7.6.4 Led lamp (matrix evo version) ....................................................................................................... 13

8 MACHINE CALIBRATION AND REGULATION ..................................................................................14

8.1 Fitting and removing tools ..............................................................................................................14

8.2 Micrometer gauge...........................................................................................................................15

8.3 Calibration / tool alignment ............................................................................................................. 16

8.4 Tracer point spring ..........................................................................................................................17

8.5 Carriage spring for laser keys.........................................................................................................18

8.6 Clamps ...........................................................................................................................................20

8.6.1 The clamp unit has several seats dedicated to the positioning of different types of keys: ............ 21

9 CUTTING ............................................................................................................................................25

9.1 Fitting keys .....................................................................................................................................25

9.2 Key stop..........................................................................................................................................25

9.3 Cutting dimple keys ......................................................................................................................26

9.3.1 Back cuts ..................................................................................................................................... 26

9.3.2 Inclined cuts................................................................................................................................... 27

9.4 Cutting laser type keys ..................................................................................................................28

9.4.1 Cutting laser keys with narrow stems ............................................................................................ 29

9.5 Cutting chet type keys (h prole) ..................................................................................................30