Silca Matrix Evo - Replacing Switches: Master and Motor on

Operating Manual Matrix
Copyright Silca 2012 39
Fig. 75 Fig. 76
10.12 REPLACING SWITCHES: MASTER AND MOTOR ON
1) Disconnect the power lead from the machine.
2) Turn the key-cutting machine onto its back and loosen the 4 screws (P4) to remove the bottom safety guard
(Fig. 75).
3) Disconnect the wires from the switch to be replaced, paying attention to their position.
4) Press the xing “tabs” on the switch so that it can be pulled out.
5) Insert the new switch into the special seat.
6) Reconnect the connectors.
7) Replace and secure the bottom safety guard with the 4 screws (P4).
8) Return the key-cutting machine to the upright position.
Fig. 77 Fig. 78