Silvercrest SCNM 100 A1 - User Interface Overview; LCD Screen Functions; Operation Button Functions

10
Introduction
EN
LCD screen
Operation buttons
①
Recommended presser foot
②
Auto-Lock button
③
Needle up/down position button
④
Buttonhole lever
⑤
Winding the lower thread
⑥
Stitch number
⑦
Stitch width
⑧
Stitch length
Start/Stop button
Press the Start/Stop button to start sewing.
Press the Start/Stop button again to stop the sewing machine.
Reverse sewing/Auto-lock button
If reverse sewing button is pressed when stitches 00-05 are
selected, the sewing machine sews backwards at low speed. The
device sews forward again after releasing the reverse sewing
button.
While the stitch number 06-19 or 29-99 is selected, the device
will immediately sew 3 locking stitches and then stop automati-
cally when the reverse sewing button is pressed.
NOTE
The sewing machine sews slowly at the beginning of the sew-
ing. The sewing speed can be adjusted via the speed adjust-
ment slider. This allows you to operate the sewing machine
without a foot controller.