EasyManuals Logo

Silvercrest SCNM 100 A1 User Manual

Silvercrest SCNM 100 A1
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
45
Sewing applications
EN
8. Use the seam ripper to cut open the center of the button-
hole.
CAUTION
When cutting the buttonhole with the seam ripper, do not place
your hands in the cutting direction, otherwise injuries may
result.
NOTE
Be careful not to accidentally cut into the bar tack. Use a pin as
a stopper at the bar tack so you do not cut too much.
7. After sewing the buttonhole stitch, raise the buttonhole lever
as far as it will go.
1
1
1. Hook a gimp thread (a heavy thread or cord) to the back
of the buttonhole foot.
2. Bring the ends of the gimp thread to the front of the foot and
insert them into the notches; then knot them temporarily.
3. Lower the two-step presser foot lever (22) and start sewing.
NOTE
Set the stitch width to match the diameter of the gimp thread.
4. Once sewing is completed, pull the gimp thread gently to
remove any slack.
5. Thread the gimp thread ends into a larger hand needle.
Pull the ends to the back of the fabric and knot them before
cutting off the overhangs
.
v
Sewing a buttonhole on stretch fabrics:
NOTE
It is suggested that you sew with a stabilizer material under the
fabric.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SCNM 100 A1 and is the answer not in the manual?

Silvercrest SCNM 100 A1 Specifications

General IconGeneral
BrandSilvercrest
ModelSCNM 100 A1
CategorySewing Machine
LanguageEnglish

Related product manuals