23
Starting up
EN
3
4
65
7
3. Wind the thread counter-clockwise around the bobbin
thread guide (2).
4. Lead the thread from the inside through a hole of the empty
bobbin (m) as illustrated. Place the bobbin on the bobbin
winder spindle (17). Align the notch
①
with the spring
of the bobbin winder spindle (2). Gently press the bobbin
down until you hear it clicks into its place.
5. Push the bobbin (m) to the right in the direction of the bob-
bin winder stopper (16). When the bobbin is in the winding
position, the LCD screen (5) shows the symbol for winding
of the lower thread.
6. Hold the thread tail securely in one hand.
7. Start winding the lower thread by pressing the foot control-
ler (r) or pressing the Start/Stop button (8).
NOTE
The speed adjustment slider setting limits the maximum sewing
speed and also limits the maximum sewing speed that can be
achieved via the foot controller.
8
8. Stop the device after a few revolutions. Cut the thread as
close as possible to the bobbin (m). Continue winding until
the bobbin is full. Once the bobbin is full, it rotates slowly.
Stop the device, then press the bobbin winder spindle (17)
to the left.
9. Cut off the thread and remove the filled bobbin from the
bobbin winder spindle (17).
10. Use only correct and neatly wound lower thread bobbins;
otherwise the needle may break or the thread tension may
not be correct. Then press the bobbin winder spindle to the
left to start sewing.
To Next Page
Loading...
Need help?
General
