Silvercrest SDG 800 B2 - Cooking; Thermal Cut-out Feature; First Time Use Preparation; Cooking Tips and Techniques

8
GB
5. Before using for the
first time
FIRE HAZARD! Before turning the
device on, place it on a level, sta-
ble, dry, heat-resistant surface.
DANGER! Risk of injury
through burning!
The surfaces of the device become
very hot during operation. During op-
eration, only touch the time selec-
tor
12 and handles 8 of the device.
NOTE: as the appliance is supplied with a
thin film of grease, there might be a small
amount of smoke and odour the first time
it is used. This is not harmful and will stop af-
ter a short while. Please ensure adequate
ventilation during this process.
• Clean the appliance before using
it for the first time (see “Cleaning
and storing” on page 17)!
1. Place the appliance on a level, dry,
non-slip surface so that the appliance
can neither fall over nor slide off.
2. Pour 0.25 l of clean drinking water into
bottom part10.
3. Put steam sleeve7 on steam genera-
tor9. The narrow end of steam
sleeve7 must face upwards.
4. Put collector6 in bottom part10.
5. Place steamer baskets4 on bottom
part10.
NOTE: ensure that the steamer baskets4
are in the right sequence, as they are slightly
different sizes. Steamer basket 1 is always
on the bottom, steamer basket 2 on top of it
and steamer basket 3 right on top. The num-
ber of the steamer basket is shown on its
handles.
6. Place rice tray3 in the top steamer
basket.
7. Place lid2 on the top steamer basket.
8. Insert the power supply plug in a suita-
ble earthed power supply socket.
9. Select a cooking time of 5 - 10 min. on
time selector12.
10. The appliance starts heating up and
operating display13 comes on.
11. Allow the appliance to cool down once
the set time has elapsed and then clean
it again. The appliance is now ready to
use.
6. Operating the appli-
ance
6.1 Cooking
FIRE HAZARD! Before turning the
device on, place it on a level, sta-
ble, dry, heat-resistant surface.
DANGER! Risk of injury
through burning!
The surfaces of the device become
very hot during operation. During op-
eration, only touch the time selec-
tor 12 and handles 8 of the device.
1. Take collector6 out of bottom part10.
2. Pour clean drinking water into bottom
part10:
- the quantity is 0.2 l to 1.2 l;
- ensure that the water level on water
level indicator11 is always between
MIN and MAX;
- with collector6 in place, you can
also pour in water via handles with
filling opening8.
3. Put steam sleeve7 on steam genera-
tor9. The narrow end of steam
sleeve7 must face upwards.
4. Put collector6 in bottom part10.
BB&3(B%ERRN6HLWH'RQQHUVWDJ$XJXVW