Silvercrest SSMS 1350 B2 - 12. Extracting Hot Water; 13. Frothing Milk

76
GB
the optimum flavour. For dark roasting
the temperature should be lower and
for light roasting higher.
• Clean your espresso machine regularly.
Coffee residues or clogged pores alter
the taste.
• Always use fresh tap water that is not
too hard. If your tap water is hard, you
can use filtered water from a commer-
cially available water filter.
12. Extracting hot
water
DANGER! Risk of injury
through scalding!
 Hot steam and hot water are released
when using the steam nozzle10. The
steam nozzle becomes very hot. Only
touch the steam nozzle by the plastic
handle. Never put hands or other parts
of your body in the steam.
You can draw hot water (approx. 80 °C)
from the steam nozzle10, for example for
an Americano or to preheat cups.
You can turn the steam nozzle10 back and
forth.
Requirement: the device is ready to be used.
The LED rings17,18 are permanently lit.
1. Place a container under the steam noz-
zle10.
2. Turn the dial4 in the direction of the
symbol .
- The LED ring 17 flashes.
- The LED ring 18 goes out.
- Hot water flows from the steam noz-
zle10.
3. Finish the operation by turning the di-
al4 back to OFF.
When the LED rings17,18 are flashing,
the device is heating up.
When the LED rings17,18 are permanent-
ly lit, the device is ready to prepare espresso
again.
NOTE: the maximum time for hot water pro-
duction is 120 seconds. The function then
stops automatically. Set the dial4 back to
OFF. You can then immediately use the func-
tion again.
13. Frothing the milk
DANGER! Risk of injury
through scalding!
 Hot steam and hot water are released
when using the steam nozzle10. The
steam nozzle becomes very hot. Only
touch the steam nozzle by the plastic
handle. Never put hands or other parts
of your body in the steam.
 When frothing milk with the steam noz-
zle10: dip the steam nozzle into the
milk before you start the steam function.
And stop the steam function before you
pull the steam nozzle out again.
NOTE: when the device is ready for steam
production, continue working quickly. Oth-
erwise the device switches to cooling mode
after a short time (the LED rings17,18
flash rhythmically). This is a protective func-
tion against overheating. In this case, press
the button 19 again to reactivate the
steam function.