83
GB
Preparing the descaling solution
DANGER! Risk of eye irrita-
tion!
When handling the supplied descaling
agent, observe the information provid-
ed, e.g. on the packaging.
A bottle of descaling agent is included in the
items supplied.
You can also use another commercially
available descaling agent for espresso ma-
chines. In this case please follow the manu-
facturer's instructions.
Descaling process
Prerequisite when prompted to descale: all
LED rings17,18,19 are permanently lit.
Prerequisite when not prompted to descale:
the device is ready to be used. The LED
rings17,18 are permanently lit.
1. Empty the water tank6.
2. Pour the entire contents of the descaling
agent bottle (approx. 125 ml) into the
water tank6.
3. Fill the water tank6 with fresh, cold tap
water up to the MAX marking.
4. Insert the water tank6.
5. To collect the descaling solution, place
a larger container (approx. 1 litre) un-
der the steam nozzle10 and another
container (approx. 500 ml) under the
brewing head14.
6. Press and hold the button 19 for
approx. 5 seconds until the 3 LED
rings17,18,19 flash twice in succes-
sion.
NOTE: the process is cancelled after
15 seconds without activity.
7. Turn the dial4 in the direction of the
symbol .
8. Press the button 19.
- The device pumps hot descaling solu-
tion through the steam nozzle10.
9. When about 450 ml of descaling solu-
tion have passed through, turn the di-
al4 to OFF.
- The descaling solution is pumped
through the brewing head14 with
pauses.
When the descaling programme has been
completed, the LED rings17,18 are lit con-
tinuously.
Rinsing process
1. Remove the water tank6 and pour
away any excess descaling solution.
2. Rinse the water tank6 several times
with clean water.
3. Fill the water tank6 with fresh, cold tap
water up to the MAX marking and in-
sert it.
4. Empty the containers for collecting the
pumped liquid and place them back un-
der the steam nozzle10 and the brew-
ing head14.
5. Press and hold the button 19 for
approx. 5 seconds until the 3 LED
rings17,18,19 flash twice in succes-
sion.
NOTE: the process is cancelled after
15 seconds without activity.
6. Turn the dial4 in the direction of the
symbol .
7. Press the button 19.
- The device pumps hot water through
the steam nozzle10.
8. When about 450 ml of water have
passed through, turn the dial4 to OFF.
- Water is pumped through the brew-
ing head14 with pauses.
When the process is complete, the LED
rings17,18 will be lit continuously.
9. Fill the water tank6 with fresh, cold tap
water up to the MAX marking.
The device is ready to prepare espresso
again.
To Next Page
Loading...
Need help?
General
