EN
8. Device configuration
48
Device configuration
8.
8.2
Data management
This menu enables you to set up alarms for certain measurements. Here, you can choose the quantity, the device, low and
high values for alarm, and you can turn the high/ low-value alarms on and off.
·
ALARM LOW: Low-value alarm fires when the measured value is lower than the setup alarm value
.
·
ALARM HIGH: High-value alarm fires when the measured value is higher than the setup alarm value
.
After you select ALARM LOW or ALARM HIGH, the following alarm settings will appear:
·
ALARM STATE - enable and disable alarm.
·
ALARM VALUE - a limit value which fires the alarm.
·
SILENT
,
if enabled, there will be no audible signal when the alarm fires. The alarm warning will only appear on PICO’s
screen.
·
ALARM DELAY, the time delay with which the alarm is fired. The alarm fires when only the measured value is below (for
alarm low) or above (for alarm high) the “alarm value” during the delay period.
·
ALARM DURATION
,
the selected alarm duration. 5 minutes by default. Setting the duration to 0 seconds will keep the
alarm active until manually dissmised.
·
OUTPUT - the digital output that is turned on during an active alarm.
·
OUTPUT MODE -
·
ON / OFF - It will toggle the alarm ON/OFF depending on the alarm value.
·
ON - It will toggle the alarm ON when the alarm value is reached.
It will not turn OFF when the conditions are no longer met.
·
OFF - It will toggle the alarm OFF when the alarm value is reached.
It will not turn ON when the conditions are no longer met.
·
OUTPUT DELAY - Time delay of firing the alarm output after the alarm conditions are met.
To Next Page
Loading...
Need help?
General
