DL100 Series Universal Low-Power Inverter
52 Detailed Description of Functions
operation, it starts to cycle from the first speed.
This group of parameter function codes is used to set the output frequency of
the terminal to control multi-speed operation.
[F5.08]～[F5.14] Multi-speed frequency 1～7 running time
Note: The running time of each stage refers to the time from the end of the
previous stage to the end of the current stage, including the acceleration or
deceleration time from running to the frequency of the current stage.
F5.01 Multi-speed frequency 1
Predetermined area
：
0.00Hz ~ upper limit frequency
F5.02 Multi-speed frequency 2
Predetermined area
：
0.00Hz ~ upper limit frequency
F5.03 Multi-speed frequency 3
Predetermined area
：
0.00Hz ~ upper limit frequency
F5.04 Multi-speed frequency 4
Predetermined area
：
0.00Hz ~ upper limit frequency
F5.05 Multi-speed frequency 5
Predetermined area
：
0.00Hz ~ upper limit frequency
F5.06 Multi-speed frequency 6
Predetermined area
：
0.00Hz ~ upper limit frequency
F5.07 Multi-speed frequency 7
Predetermined area
：
0.00Hz ~ upper limit frequency
F5.08 Phase 1 running time Predetermined area
：
0.0 ~ 6000.0 Sec
F5.09 Phase 2 running time Predetermined area
：
0.0 ~ 6000.0 Sec
F5.10 Phase 3 running time Predetermined area
：
0.0 ~ 6000.0 Sec
F5.11 Phase 4 running time Predetermined area
：
0.0 ~ 6000.0 Sec
F5.12 Phase 5 running time Predetermined area
：
0.0 ~ 6000.0 Sec
F5.13 Phase 6 running time Predetermined area
：
0.0 ~ 6000.0 Sec
F5.14 Stage 7 running time Predetermined area
：
0.0 ~ 6000.0 Sec
To Next Page
Loading...
