2-3
Use the following procedure if the Global Acknowledge option is enabled on your 4100 system.
1. Unlock and open the enclosure door. Read the alphanumeric display on the interface panel.
It reports the number of alarm conditions as shown below.
2. Press the ALARM ACK key. Read and follow the instructions on the alphanumeric display.
After you press the ALARM ACK key, the system responds as follows:
• The tone-alert silences and the alphanumeric display reports pertinent information about
the alarm, such as the following:
• The SYSTEM ALARM LED changes from flashing to steady ON, and all alarm
conditions are acknowledged.
• Pressing the ALARM ACK key again displays information on the next alarm. Continue
to do this to review all alarms in the system.
Use the following procedure if the Individual Acknowledge option is enabled on your 4100
system.
1. Unlock and open the enclosure door. Read the alphanumeric display on the interface panel.
It reports the number of alarm conditions as shown below.
2. Press the ALARM ACK key. A report similar to the one shown below appears. Read and
follow the instructions on the alphanumeric display.
Continued on next page
Acknowledging an Alarm, Continued
Globally
Acknowledging
Alarms
Individually
Acknowledging
Alarms
**FIRE**
Press <ACK> to review.
Fire =1 PRI2 = 0 SUPV = 0 TRBL=0
FIRST FLOOR EAST WING ROOM 31
PULL STATION FIRE ALARM
**FIRE**
Press <ACK> to review.
Fire =1 PRI2 = 0 SUPV = 0 TRBL=0
FIRST FLOOR EAST WING ROOM 31
Press ACK key to acknowledge ALARM
PULL STATION ALARM
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
