Simplex 4100U User Manual

3-1
A Trouble message is used to indicate the presence of a circuit break or ground within a system
point, or somewhere between the 4100 and one of its points.
This chapter describes using the Operator Interface Panel keys to investigate the details of the
trouble condition.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Overview 3-2
Acknowledging Troubles 3-4
If the Trouble Doesn’t Clear 3-6
Chapter 3
Trouble Conditions
Introduction
In this Chapter
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com

Simplex 4100U Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Display	LCD
Power Supply	120/240 VAC, 50/60 Hz
Max Signaling Line Circuits (SLC)	2
Operating Temperature	0°C to 49°C (32°F to 120°F)
Humidity Range	10% to 93% non-condensing
Network Capability	Yes
Communication Protocol	RS-232, RS-485
Battery Backup	24 VDC
NAC Outputs	4
Signaling Line Circuits (SLCs)	2
Power Supply Current	3.0 A
Max Notification Appliance Circuits (NAC)	4
Max Releasing Circuits	4
Max Relay Circuits	4
Communication Ports	RS-232, RS-485