5-4
Direct Point Call-up
Screen Options
Figure 5-2 shows an example of the Direct Point Call-Up screen. The options available in the
Direct Point Call-Up screen are listed in the table below:
Figure 5-2. Direct Point Call-up Screen
P / A / L - allows you to select a
digital (P), analog (A), or List
(L) pseudo point.
Enter the number corresponding to the digital pseudo, analog pseudo, or
list point. For example, pressing the P key and entering a 1 selects the
alarm silence key pseudo point.
NET - allows you to select a
network point.
Enter a network NODE number. The system then prompts for the type of
point you want to select. Press the keypad key corresponding to the type
of point (E.g., Zone or Signal) Use the descriptions above for information
on selecting the specific point.
ADDR = address of the point in
the system.
Specify the address using the format C-P-S, where C is the card, P is the
point, and S is the subpoint. You must insert the dash between the com-
ponents of the address. Use the NET key to enter the dash.
Key
Data to Enter
Action
Description
Full Label
Shows the entire custom label on the line. Release the button to revert back to the standard format.
Enable Enables the selected point.
Disable Disables the selected point. Refer to 579-688 for guidelines on disabling active points.
Select
Item
Displays point information on screen. “Enter” can also be pressed to display the point info to the
display.
Delete Deletes a character from the prompt. When searching for a point, the screen will attempt to match
the point based on the keys pressed. Deleting a character will force an additional match attempt
based on the remaining characters.
CLR/Exit Exits the screen. The CLR/Exit button on the entry keypad can also be used to exit the screen.
To Next Page
Loading...
