Simplex InfoAlarm 4100U User Manual

6-3
Setting System Time and Date
Overview Follow these steps to set the time and date used by the FACP. Ensuring that the current time and
date are correct on the system is important. In particular, the accuracy of historical logs and reports
depends on the system time.
Procedure 1. Press the MENU key. Press the NEXT or PREVIOUS key until the display shows the option
for setting time and date.
2. Press the ENTER key. The system responds as follows:
Figure 6-2. The Set Date Screen
3. The display shows the current date followed by a the new date filled by blank underlined
characters. Use the entry keys to enter the new date, or press ENTER to leave the date
unchanged.
4. The next screen displays the time in a similar format to the Figure 6-2. Use the entry keys to
enter the time, and press ENTER when complete. To leave the date unchanged, press ENTER
without entering a new time.
firealarmresources.com

Simplex InfoAlarm 4100U Specifications

General

Display	LCD
Power Supply	120/240 VAC, 50/60 Hz
User Interface	Keypad and LCD
Type	Addressable Fire Alarm Control Panel
Operating Voltage	24 VDC
Communication	Ethernet (optional)
Compatibility	Simplex devices
Operating Temperature	0°C to 49°C (32°F to 120°F)
Humidity Range	10% to 93% non-condensing