To Next Page

To Previous Page

CR44/54 Waypoint / route menu Chapter 8-19

Press [MENU] to exit and *reboot (only if loading “Setup”)

*) When the system makes a ‘reboot’ the screen will turn black for a

brief moment, then the system will re-start and automatically return

to the active display which was on the screen before you made the

transfer.

8.9.1 List of criteria for data transfer in the Action column

OVERWRITE - will overwrite existing data in the memory you are trans-

ferring data to. Whenever a new ‘Setup’ is transferred into the main unit, the

system will reboot, the screen will turn black for a brief moment and then

restart and automatically return to the active display on the screen before you

made the transfer.

 Transfer of ‘Setup’ can only be completed between identical units.

MERGE - will mix the transferred data with the data in the memory you are

transferring to. Press [ENT] to calculate memory after merge. Identical data

will be sorted automatically and not saved twice i.e.:

• ‘Marks/waypoints’ of same position, name and symbol.

• ‘Lines’ which are identical.

• ‘Routes’ of same name, equal number of routepoints (not necessarily in the

same position), but with the exact same start point and end point.

• ‘Targets’ of same position, name and symbol.

• ‘Tracks’ which are identical.

• ‘Setup’ can not be merged.

DELETE - will delete existing type of data from the memory you are trans-

ferring data to.

NO - no action will take place. The data will remain unchanged.

Simrad CR44 Manual

Other manuals for Simrad CR44