CR44/54 Setup menu Chapter 9-13
DELETE MEMORY:
1
Delete all WAYPOINTS
2
Delete all ROUTES
3
Delete all LINES
4
Delete all TRACKS
5
Delete all TARGETS
Used memory: 0%
FACTORY PRESETS:
6
Return to NMEA presets
7
Return to CHART presets
8
Return to RADAR presets
CLR
Return to all factory presets
0
Show test display
MENU
Exit
ENT
If you are absolutely sure, press [ENT] to complete the job
MENU
If not absolutely sure, press [MENU] to exit function without having
made any changes
POWER OFF - RESET
In case, for some reason, the unit is totally locked i.e. no immediate
response from the keypad, then first try to reset the unit by discon-
necting the power supply. Reconnect the power cable and then start
up the unit again by presssing and holding the [PWR] key until a
picture appears on the screen.
MASTER RESET (will return all settings to factory presets)
If the Power off - reset does not solve the problem, you may have to
perform a master reset by disconnecting the power supply, and then
while reconnecting the power cable you will have to press the [PWR]
and [CLR] keys at the same time, and hold both keys depressed until
a picture appears on the screen. All user-made data will be erased,
and all settings are returned to factory presets.
To Next Page
Loading...
Need help?
General
