CR44/54 Radar menu Chapter 3-19
Rpm – will determine the scanner rotation (full screen presentation).
The rotation speed will be controlled automatically when leaving
Scanner type to Auto detect in Radar setup (MENU,7,RADAR).
Manually, the rotation speed can be set to either 24 or *48 rpm,
depending on the scanner type (use +/- keys).
*Running 48 rpm is liable to reduce the lifetime of the mechanical
parts.
HDG
– your heading will be shown (full screen presentation) in
degrees from connected compass. If no compass is connected, you can
use the course (COG) from the built-in GPS module by setting “Head-
ing” OFF in NMEA INPUT interface setup in [MENU], [7], [2].
When using the GPS course as replacement for heading input, the
accuracy will be reduced in relation to speed, wind and current.
To Next Page
Loading...
Need help?
General
