Simrad IS12 - CALIBRATION

Instruction Manual
17
E04052
3 CALIBRATION
To protect the calibration functions, these are held in a hidden
menu. To enter calibration mode, press and hold the LIGHT
key (Fig 3.1) -
Fig 3.1 - Entering Calibration Mode
Once in calibration mode, pressing the (ALARM TIMER)
and (UPPER INFO) keys will cycle through the available
calibration options -
- Units (Section 3.1)
- Damping (Section 3.2)
- Depth Offset (Section 3.3)
- Depth Transducer On/Off (Section 3.4)
- Speed Sensor Calibration (Section 3.5)
- Race Countdown Time (Section 3.6)
- Local / Network Backlighting (Section 3.7)
- Shop Mode (Section 3.8)
- Disabling Remote Control Facility (Section 3.9)
To exit calibration mode, press and hold (LIGHT).
ALARM
TIMER
LOWER
INFO
UPPER
INFO
COMBI
LIGHT
ALARM
TIMER
UPPER
INFO
LOWER
INFO
LIGHT