Instruction Manual
29
E04052
3.8 Shop Mode
This is a simulation mode for in-store demonstration - do not
use.
3.9 Disable Remote Control
On some installations which includes the IS12 Remote Control,
it may be more convenient to limit remote control access to
only some instruments on the network - for example on a fly-
bridge power boat with a set of instruments on both steering
stations, it would not be desirable to be able to control the
instruments on the flybridge (Fig 3.15) -
To disable remote control functionality on this display, enter
calibration mode, press six times (the display will show
CTRL CAL on the top line) and press (INFO).
The large digits will show the current setting - ON for remote
control enabled or OFF for remote control disabled. The set-
ting can be changed using the or keys.
To set the selected mode, press . The display will then return
to the main calibration menu.
NOTE Press to exit to the main calibration menu at any point.
NOTE Any changes will affect this specific instrument only.
For further information on Remote Control operation, please
refer to the user manual supplied with the Remote Control /
Alarm unit.
Main Steering Station
Flybridge
Rear mounted instruments - remote control required.
Remote control enabled
Front mounted instruments - no remote control required
Remote control disabled
Fig 3.15 - Flybridge system with Remote control of main steering
system only
To Next Page
Loading...
Need help?
General
