IS12 Combi
22
E04052
3.4 Switching Depth Transducer Off / On
If the boat is also fitted with a fishfinder running at a different
frequency, there may be some interference between the two
depth transducers. In this case, the transducer can be switched
off. This is also useful to conserve power when on a long
ocean crossing, where the depth sounder is not needed.
Enter calibration mode, press x3 (the display will show CAL
TRAN) and press .
The display will show “On”. To turn the transducer off, press
the or key (the display will show “OFF”) and press to
confirm (Fig 3.6). The display will then return to the main cali-
bration menu.
Fig 3.6 - Turning Depth Transducer Off/On
While the transducer is set to off, the main depth display will
show OFF.
To turn the transducer back on again repeat the above proce-
dure.
NOTE Press to exit to the main calibration menu at any point.
LIGHT
LOWER
INFO
ALARM
TIMER
UPPER
INFO
COMBI
To Next Page
Loading...
Need help?
General
