IS12 Combi
26
E04052
When the boat reaches the start of the measured distance, press
the key - the display will show “run” (Fig 3.11) -
Fig 3.12 - Selecting Leg 2 of Measured Distance Run
Fig 3.11 - During Measured Distance Run
At the end of Leg 2 press to calibrate the log as an average
of the two Legs and return to the main calibration menu.
NOTE Press to abort to the main calibration menu at any point.
LIGHT
LOWER
INFO
ALARM
TIMER
UPPER
INFO
COMBI
Press the key to cancel the calibration.
At the end of the measured distance run, press . The display
will show “End”. To calibrate the log based on the Leg 1 run
only press again - the display will then exit to the main cali-
bration menu.
To re-run Leg 1 again, press or to select “LEG1” and
repeat the above procedure.
For maximum accuracy, the run should be repeated in the
opposite direction - press or to select “LEG2” (Fig 3.12)
and repeat the above procedure.
To Next Page
Loading...
Need help?
General
