24 |
Refuelling | Simrad IS35 User manual
Adding fuel
1. Make sure the vessel setup is complete and the
number of tanks and total fuel capacity is set to the
correct value.
2. Enter the amount of fuel added to the tank into the
Amount added section, or select Set to full when
lling the tank to its maximum capacity
Fuel used
The fuel Used dialog shows how much fuel has been
used since last ll, from trip reset and seasonal usage
(continuous recording).
Note: If more than one engine is on the network, then
the Fuel Used data shown is the total for all engines. It
also lists the data for each engine.
To Next Page
Loading...
