Simrad IS35 - Device Specific Settings; Device Configuration Options; NMEA2000 Diagnostics; Measurement Unit Selection

34 |
Settings | Simrad IS35 User manual
Con gure
All units come pre-con gured but they can be
modi ed once connected to the network. The
example below shows how to con gure the engine
location.
 Note: Con guring the engine location correctly is
important when more than one engine is on the
network.
Some devices show additional options speci c to
the device. For example the Calibrate option, to
allow easy setup of a device. Calibration options vary
depending on the device.
Diagnostics
NMEA2000 Bus diagnostic data on the network.
Units
Set the unit of measurement for how you want the
data to be displayed.