Name: Simrad NSS evo3
Brand: Simrad
Rating: 5 (1 reviews)

To Next Page

To Previous Page

1 Avoid mounting within 1 m (3.3’) to port (left) of propeller

2 Conventional clockwise propeller rotation

3 Avoid mounting within 7.5 cm (3“) to starboard of propeller

4 Best mounting location - undisturbed water flow

5 Planing strake - avoid mounting behind here

Note: Reverse the distance guides (1 & 3) from propeller where engine is of

counterclockwise configuration.

Note: Vessels with strakes or ribs on the hull can create large amounts of turbulence at

higher speeds. A good transducer location on these types of boats is between the ribs

closest to the engine.

Note: If the transducer is not placed in a smooth flow of water, interference caused by

bubbles and turbulence may show onscreen in the form of random lines or dots. The

unit could also lose bottom signal when the boat is on plane.

Note: Trim tabs vary in the amount of turbulence they create as they are adjusted, stay

clear of these.

Transducer installation

For transducer installation information, refer to separate installation instructions included

with the transducer.

Installation | NSS evo3 Installation Manual

Other manuals for Simrad NSS evo3

Questions and Answers:

Need help?

Do you have a question about the Simrad NSS evo3 and is the answer not in the manual?

General