Instruction Manual
53
E04819 Issue 1.0
Use the numeric keypad to enter the number (Fig 5.3). Press the
C
ALL
and MSG
keys to move the cursor to correct any errors.
The cursor position is indicated by the number flashing – enter a
new number to overwrite an incorrect number.
5.3 Entering a number
Press OK to begin entering a new number – the large digits will
show the entry number in the directory (1 if it is the first entry).
Enter the name first – use the VOL ▲ or VOL ▼ keys to scroll
through the alphabetical characters and use the numeric keypad
to enter any numbers (Fig 5.2).
Press M
SG
to move the cursor forward, or CALL
to move
back and correct any errors. The cursor position is indicated by
the character flashing; to overwrite enter a new character. Press
O
K to confirm the entry and move on to the MMSI entry.
1 0 1
SEASP-----
----------
DIR
INT
Fig 5.2 - Entering a new name into the directory
1 0 1
SEASPRAY 0
47539-----
DIR
INT
Fig 5.3 - Entering the number
Press OK to confirm and store the entry to the directory.
Press ON/C at any time to abort to the default display.
Note If using the Boat or Coast Station MMSI directories, the entry
will not be accepted, unless all nine digits of the MMSI number
have been entered.
To Next Page
Loading...
Need help?
General