Simrad V5035 - Alarm List

| 51
Operation | V5035 Operator and Installation Manual
Region list
The region list displays all saved region areas. Turn the knob to
traverse the list. Press the knob enables you to read the highlighted
region information.
REGION SETTING LIST
2013/01/17 23:26:20
--- Region No---- Source ------- Date/Hour --
Region 1 ACA 12/01/02
Region 2 ACA 12/01/02
Region 3 N/A 11/11/01
Region 4 N/A 11/11/01
Region 5 N/A 11/11/01
Region 6 N/A 11/11/01
Region 7 N/A 11/11/01
Region in Use [Region 9]
T. Zone Status [No ]
Tar
g
ets Received: 10
REGION [1] SETTING
2013/01/17 22:43:39
Tar
g
ets Received: 10
LAT(NE) 020
°
24’00”N
LON(NE) 123°58’00”E
LAT(SW) 019°35’00”N
LON(SW) 123°04’00”E
T.Zone (NM) 5
Channel A 2023
Channel B 2023
TX/RX Mode TxA/ TxB/ RxA/ RxB
Addr/Broad ACA Sentence
Band Width 25K Hz
Power Low
Band Width 25K Hz
>TZ<
SW
NE
Region list and region setting
Editing existing region content
You can modify the region area setting by pressing FUNC button
at the region information page. Use the scroll wheel to scroll to the
field to edit, then press the knob to enter the value.
REGION [1] SETTING
2013/01/17 22:43:39
Tar
g
ets Received: 10
LAT(NE) 020°24’00”N
LON(NE) 123°58’00”E
LAT(SW) 019°35’00”N
LON(SW) 123°04’00”E
T.Zone (NM) 5
Channel A 2023
Channel B 2023
TX/RX Mode TxA/ TxB/ RxA/ RxB
Addr/Broad ACA Sentence
Band Width 25K Hz
Power Low
Band Width 25K Hz
>TZ<
SW
NE
Edit Region?
YES NO
REGION LIST [1]
2013/01/17 22:43:39
Tar
g
ets Received: 10
LAT(NE) [20]°[24]’[00]”<N>
LON(NE) [123]°[58]’[00]”<E>
LAT(SW) [19]°[35]’[00]”<N>
LON(SW) [123]°[04]’[00]”<E>
T.Zone (NM) [5]
Channel A [2023]
Channel B [2023]
TX/RX Mode <TxA/ TxB/ RxA/ RxB>
Band Width [25]
Power <High>
Band Width [25]
Modify region content
To save the settings, press MENU or ESC and the system will ask
whether the changes should be saved. Select OK to save or CANCEL
to discard and return to main menu. If the region information is
unchangeable, saving does not change the original information.
Alarm list
V5035 features SART/MOB alarm that can appear any time during
operation. When SART/MOB message is received, the
icon will
appear in the status bar with beeping sounds from the beeper. Press
any button to stop the sound. An example of an alarm message is
shown below.