Simrad V5035 - Own Ship Settings

56 |
Operation | V5035 Operator and Installation Manual
Own ship
This section is password protected and can only be accessed using
the password (page 66).
The following information about the vessel should be correctly set
up by installation prior to operation:
• Call Sign - Vessel radio call sign (limited to 7 characters)
• Ship Name - limited to 20 characters
• Ship Type – use the scroll wheel to select the type of vessel from the
list
• Position of internal GPS antenna - giving the location of the GNSS
antenna connected to the AIS transceiver (Internal GPS)
• Position of external GPS antenna - giving the location of the GNSS
antenna connected to any external position source connected to
the AIS transceiver
• Length and Beam – measured length and width of the ship (inland
mode only)
SHIP SETTING
2015/01/17 22:43:39
SHIP NAME [SIMRAD
SHIP TYPE <Pilot vessel>
INTERNAL ANT. POS. (m)
EXTERNAL ANT. POS. (m)
A
B
C D
A [000] B [000] C [00] D[00]
A [000] B [000] C [00] D[00]
CALL SIGN [WQOH909 ]
Dangerous Targets :10
SHIP SETTING
2015/01/17 22:43:39
SHIP TYPE <HSC>
---- Length and Beam (m) ----
---- INTERNAL ANT. POS.(m) ----
---- EXTERNAL ANT. POS.(m) ----
AI
BI
CI DI
Dangerous Targets :10
SHIP NAME [B ]
CALL SIG [A ]
HINT: LS=AI+BI , BS=CI+DI
BI [000.0] CI [000.0]
BI [000.0] CI [000.0]
LS [000.0] BS [000.0]
IL
Ship setting in SOLAS mode (left) and inland mode (right)
¼ Note: if Ship Type is Tanker, by regulation, whenever the ship naviga-
tion status is “Moored”, the transponder’s transmission power is
automatically changed to 1W for safety measures.