Simrad V5035 - Password Management

66 |
Operation | V5035 Operator and Installation Manual
restored to their original value: MOB/Friend ship List, destination list,
time zone, language, dimmer, CPA/TCPA and system password.
MENU
2013/01/17 07:18:11
Dangerous Targets :0
MAIN MENU
MESSAGES
NAV. STATUS
SHIP SETTING
TRANSCEIVER
SYS CONFIG
DIAGNOSTICS
Restore factory seng?
OK CANCEL
WARNING
Factory setting
Password
This submenu enables users to change user password. Certain
important information stored within the transponder can only be
changed with the password. Password is required for the access of
the following sections:
• Own Ship (page 48) – contains information about call sign, vessel
name and ship type
• Set MMSI/IMO/ENI (page 58) – contains information about MMSI
and IMO number
• Transceiver (page 62) – enables the option to activate/deactivate
AIS transmission
• Sensor Configuration (page 65) – about baud rate configuration
of sensors
• Factory (page 65) – restoration of factory setting
• Alarms Setting (page 68)
• VSWR Setting (page 68)
(Default password: “0000”)
Use the knob in the order of “OLD PASSWORD”, “NEW PASSWORD”,
“CONFIRM NEW PASSWORD”. Repeat till all four values are entered.
To save the settings, press MENU or ESC and the system will ask
whether the changes should be saved. Select OK to save or CANCEL
to discard and return to main menu.