NANYTE BEAM Manual
NANYTE BEAM Manual BM-001-A3 / V1.1a Page 6 of 33
Contact Information
If you have any questions, please contact your local NANYTE representative. Alternatively, you
Packing List
Due to its low weight and compact size, NANYTE BEAM is shipped in a 50 x 50 x 50 cm corrugated
cardboard box with foam protection.
1 x NANYTE BEAM
1 x NANYTE BEAM ENGINE
1 x C13 AC supply cord (appropriate plug types for the region will be supplied)
1 x 2 meter USB 3.0 Type B cable
1 x Quick start guide
1 x Factory Acceptance Test report
1 x Allen key set
1 x User manual
1 x Pre-configured laptop with international warranty (optional)
Unpacking and installation
For unpacking instructions, please refer to the quick start guide that is shipped with the system.
Please refer to the quick start guide.
CAUTION: During shipping, locking screws are used to hold components in place. Failure to
remove the screws may damage the equipment.
Product overview
NANYTE BEAM is a full-feature compact maskless UV lithography system intended for rapid
prototyping of nano and microdevice. Maskless lithography enables nanopatterning at will,
without the need for slow and expensive photomasks. This convenience is especially useful for
research and rapid prototyping use. The NANYTE BEAM compliments the existing benefits by
bringing it to the desktop without any compromise in performance.
Compact.
Full-featured maskless lithography, smaller than a desktop computer.
www.simtrum.com
may contact us direct via the most updated contact information on our website.
To Next Page
Loading...