RFC-1 Programming Examples page 7.9
The pager number is programmed. Jump to a new address to program the site ID number. This is the telephone
number of the site where the RFC-1 is installed. Any number that helps you identify the specific site should work but
many paging systems require a telephone number.
32. Jump to a new address in advanced programming mode: 80
33. Enter the starting address from the address table for Telephone Number E: 0696
34. Enter the first digit of the telephone number: 10
35. Press the # key to write this value and increment to the next address in memory
36. Enter the second digit of the telephone number: 2
37. Press the # key to write this value and increment to the next address in memory
38. Enter the third digit of the telephone number: 2
39. Press the # key to write this value and increment to the next address in memory
40. Enter the fourth digit of the telephone number: 8
41. Press the # key to write this value and increment to the next address in memory
42. Enter the fifth digit of the telephone number: 3
43. Press the # key to write this value and increment to the next address in memory
44. Enter the sixth digit of the telephone number: 5
45. Press the # key to write this value and increment to the next address in memory
46. Enter the seventh digit of the telephone number: 0
47. Press the # key to write this value and increment to the next address in memory
48. Enter the eighth digit of the telephone number: 0
49. Press the # key to write this value and increment to the next address in memory
50. Enter the ninth digit of the telephone number (optional alarm channel display): 11
51. Press the # key to write this value and increment to the next address in memory
52. Enter the tenth digit of the telephone number (optional # key terminator): 12
53. Press the # key to write this value and increment to the next address in memory
54. Enter the eleventh digit of the telephone number (unused): 10
55. Press the # key to write this value and increment to the next address in memory
56. Enter the twelfth digit of the telephone number (unused): 10
57. Press the # key to write this value and increment to the next address in memory
58. Press the ❊ key to exit the programming mode
The first digit of the site ID number at memory address 0696 must be 10. This stops the calling routine from dialing
the site ID as a contact telephone number. It would be useless to have the site call itself to report an alarm.
It is not necessary to program any specific values for the call mode or number of attempts for telephone number E
(addresses 0708 or 0709). They are ignored when this area is used to store a site ID for paging.
To Next Page
Loading...
Need help?
General
