RFC-1 Programming Examples page 7.8
7.8 Text Pager—Voice Mode
In this example we will program Telephone Number B with a voice pager number to call when an alarm occurs. We
will use the fictitious telephone number 555-1212 for the pager number. Text pager calls require a site ID number to
be programmed at Telephone Number E. We will use 228-3500 for the site ID number. Unused digits will be filled
with the value 10. And because this telephone number dials a paging system, which is not likely to be busy, we will
set the call attempts to 1.
The RFC-1 can optionally send the channel number that caused the alarm when it sends a message to a text pager
in voice mode. Programming the value 11 after the site ID number activates this feature. This feature may not be
compatible with all paging systems. In this example, we will include this option.
Some paging systems require the user to send the # key to terminate the message. The RFC-1 can send the # key
by programming the value 12 as the last digit of the site ID number. This feature is not necessary for all paging
systems. In this example, we will include this option.
1. Enter the advanced programming mode: 80
2. Enter the advanced programming security code: 4150
3. Enter the starting address from the address table for telephone number B: 0654
4. Enter the first digit of the telephone number: 5
5. Press the # key to write this value and increment to the next address in memory
6. Enter the second digit of the telephone number: 5
7. Press the # key to write this value and increment to the next address in memory
8. Enter the third digit of the telephone number: 5
9. Press the # key to write this value and increment to the next address in memory
10. Enter the fourth digit of the telephone number: 1
11. Press the # key to write this value and increment to the next address in memory
12. Enter the fifth digit of the telephone number: 2
13. Press the # key to write this value and increment to the next address in memory
14. Enter the sixth digit of the telephone number: 1
15. Press the # key to write this value and increment to the next address in memory
16. Enter the seventh digit of the telephone number: 2
17. Press the # key to write this value and increment to the next address in memory
18. Enter the eighth digit of the telephone number (unused): 10
19. Press the # key to write this value and increment to the next address in memory
20. Enter the ninth digit of the telephone number (unused): 10
21. Press the # key to write this value and increment to the next address in memory
22. Enter the tenth digit of the telephone number (unused): 10
23. Press the # key to write this value and increment to the next address in memory
24. Enter the eleventh digit of the telephone number (unused): 10
25. Press the # key to write this value and increment to the next address in memory
26. Enter the twelfth digit of the telephone number (unused): 10
27. Press the # key to write this value and increment to the next address in memory
28. Enter the calling mode for this telephone number (text pager in voice mode): 3
29. Press the # key to write this value and increment to the next address in memory
30. Enter the number of call attempts for this telephone number: 1
31. Press the # key to write this value and increment to the next address in memory
This example continues on the next page.
To Next Page
Loading...
Need help?
General
