RFC-1 Basic Operation page 5.9
5.7 Operating Commands / Programming Notes
It may be helpful to keep a table of normal programming for the RFC-1. This serves not only as a reminder of the
current programming but it also acts as a handy guide to remember how to change some common system settings.
Command Function Factory Setting Current Setting
00 Select channel 00 n/a n/a
nn Select channel nn n/a n/a
63 Select channel 63 n/a n/a
64 Auto-scan channels n/a n/a
66 Enable control functions 66 n/a
70 Set calendar 00/00/0000 n/a
71 Set clock 00:99:00 n/a
72 Main Security Code 12345678 ________________________
73 Control Security Code 66 ________________________
74 Basic Programming Security Code 4088 ________________________
76 Ring Number 2 ____
78 Firmware Version 6.xx n/a
81 Power Failure Alarm Status 0 ____
82 Telemetry Alarm Status 0 ____
86 Telephone Number A ************ ________________________
87 Telephone Number B ************ ________________________
88 Telephone Number C ************ ________________________
89 Telephone Number D ************ ________________________
90 Alarm A 64 / 2040 / 1020 ____ / ________ / ________
91 Alarm B 64 / 2040 / 1020 ____ / ________ / ________
92 Alarm C 64 / 2040 / 1020 ____ / ________ / ________
93 Alarm D 64 / 2040 / 1020 ____ / ________ / ________
94 Alarm E 64 / 2040 / 1020 ____ / ________ / ________
95 Alarm F 64 / 2040 / 1020 ____ / ________ / ________
96 Alarm G 64 / 2040 / 1020 ____ / ________ / ________
97 Alarm H 64 / 2040 / 1020 ____ / ________ / ________
98 Hang-up and ignore n/a n/a
99 Hang-up n/a n/a
To Next Page
Loading...
Need help?
General
