RFC-1 Table of Contents ii
4.2 Auxiliary Circuits 4.3
Audio Detection 4.3
Latching Relays 4.4
Telemetry Pulse Stretching 4.4
Battery Backup 4.5
Section 5 – Basic Operation
5.1 Overview 5.1
5.2 Operation from the Local Telephone 5.1
Connecting to the RFC-1 5.1
Selecting a Channel 5.1
Reading Telemetry Channels 5.2
Operating the Control Relays 5.2
Issuing other Commands 5.2
Disconnecting from the RFC-1 5.2
5.3 Operating from a Remote Telephone 5.3
Connecting to the RFC-1 5.3
Operating the RFC-1 5.3
Disconnecting from the RFC-1 5.3
5.4 Alarm System 5.4
How the Alarm System Works 5.4
Alarm System Setup 5.4
Programming Alarm Limits 5.5
Programming Telephone Numbers 5.5
Enabling / Disabling the Telemetry Alarm System 5.5
Enabling / Disabling the Power Failure Alarm 5.6
System Limitations 5.6
5.5 Clock and Calendar 5.7
Setting the Calendar 5.7
Setting the Clock 5.7
5.6 Basic Programming 5.7
Security Codes 5.7
Ring Number 5.7
5.7 Operating Commands / Notes 5.8
Section 6 – Advanced Operations
6.1 Introduction 6.1
6.2 Advanced Programming 6.1
Programming Address Table 6.2
Using the Programming Mode 6.3
Restore Factory Settings 6.4
6.3 Telemetry Channels 6.5
Telemetry Channel Programming 6.5
Unit Words 6.5
Status Readings 6.6
Maximum Scale and Decimal Point 6.7
Linear and Logarithmic Scales, Inverted Status and Auto-control Relay 6.7
Indirect Power 6.8
Telemetry Leading Zero Suppression 6.10
Telemetry Settling Time 6.10
Number of Telemetry Channels Available 6.11
To Next Page
Loading...
Need help?
General
