RFC-1 Table of Contents iv
6.9 Security Codes 6.51
Security Code Programming 6.51
Control Security Code Mapping 6.51
Incorrect Code Lockout / Communication Mode Switch Delay 6.52
6.10 Site ID and Other Options 6.53
Site Identification Phrase 6.53
Hardware Version 6.54
Inactive System Timeout 6.54
6.11 Operating Commands / Notes 6.55
Section 7 – Programming Examples
7.1 Telemetry Channel—unit word, full scale, decimal point 7.2
7.2 Site Identification Phrase 7.1
7.3 Action Sequence 7.3
7.4 Date/Time Trigger 7.4
7.5 Alarm Limits—Analog Channel 7.5
7.6 Alarm Limits—Status Channel 7.6
7.7 Voice Mode Telephone Number 7.7
7.8 Text Pager—Voice Mode 7.8
7.9 Logging Readings—Local Printer 7.10
7.10 Tower Light Alarm 7.11
7.11 Tower Light Alarm Block—Daylight Hours 7.12
Section 8 – Troubleshooting and Service
8.1 Common Problems and Possible Solutions 8.1
8.2 Factory Service Policy 8.3
Section 9 – Specifications
9.1 Electrical and Mechanical 9.1
RFC-1 Remote Facilities Controller 9.1
RP-8 Relay Panel 9.1
9.2 Schematic Diagrams 9.2
Appendix A – Programming Address Table
0000 Telemetry Channels A.1
0256 Date/Time Triggers A.6
0640 Telephone Numbers A.14
0724 Action Sequences A.16
0852 Alarms A.18
0948 Security Codes A.20
0984 Site ID Phrase A.21
0996 Operating Parameters A.22
Appendix B – Word Table
Vocabulary List B.1
To Next Page
Loading...
Need help?
General
