Singer SE9150 - Preparations; Unpacking Machine and Embroidery Unit; Connect to the Power Supply; Packing Machine after Sewing

C
B
A
10 – Preparations
PREPARATIONS
After lifting the machine out of the box and removing all packing material and the plastic bag, wipe the machine, particularly around
the needle and needle plate to remove any oil before sewing.
When unpacking the embroidery unit, do not throw away the white styrofoam inside the machine box, as this is designed for storing
the embroidery unit when not in use.
Note: Your sewing machine is adjusted to provide the best stitch result at normal room temperature. Extreme hot and cold tempera-
tures can aect the sewn result.
1. Switch the main switch o. After switching o, residual
power may still remain in the machine. This may cause
the light to stay on for a few seconds while the power is
consumed. This is normal behavior for an energy ecient
appliance.
2. Unplug the cord from the wall socket and then from the
machine.
3. Wind the cord around the foot control for easy storage.
4. Place all accessories in the accessory tray. Slide the tray on
to the machine around the free arm.
5. Place the foot control and cord in the space above the free
arm.
Among the accessories you will nd the power cord and the
foot control.
On the bottom right side of the sewing machine, you nd the
connecting sockets and the ON/OFF button.
1. Connect the foot control cord to the front socket on the
bottom right side of the machine (A).
2. Connect the power cord to the rear socket on the bottom
right side of the machine (B). Plug the cord into the wall
socket.
3. Press the ON/OFF switch (C) to "I" to turn on power and
light.
Sewing speed is regulated by pressing the foot control. The
maximum sewing speed can be adjusted using the Speed Con-
trol Lever.
Unpacking Machine and Embroidery Unit
Packing Machine after Sewing
Connect to the Power Supply
For the USA and Canada
This sewing machine has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to t in a polarized outlet only one way. If
the plug does not t fully in the outlet, reverse the plug. If it
still does not t, contact a qualied electrician to install the
proper outlet. Do not modify the plug in any way.