Singer SE9150 - Change Sewing Direction; Finish Sewing; Seam and Overcast

38 – Sewing
To change sewing direction, stop the machine. Press the Needle
Stop button to activate the Needle Up / Down position button.
The needle is brought down into the fabric.
Raise the presser foot.
Pivot the fabric around the needle to change sewing direction
as desired. Lower the presser foot and continue sewing in the
new direction.
Press and hold the Reverse button and sew a few stitches in
reverse when you reach the end of the seam. This will secure
the seam so the stitches don't unravel.
Turn the handwheel toward you to raise the needle to its
highest position. Raise the presser foot and remove the fabric,
pulling the threads to the back.
Pull the threads up and into the thread knife so that the threads
are cut the proper length and your needle won't come unthread-
ed when you start the next seam.
Note: Your machine can only sew straight stitch and zigzag
stitch - 1-001 to 1-003, 1-008, and 1-010 to 1-012 in reverse.
The seam/overcast stitch sews the seam and overcasts the
edges all at one time. The seam/overcast technique is perfect
for stitching ribbed neckbands and cus. There are a number
of dierent seam/overcast stitches in your machine. Overcast
fabric edges to prevent fraying and to help them lay at. It is
easier to overcast before the garment is sewn together.
Change Sewing Direction
Finish Sewing
Seam and Overcast
Needle Up / Down Button
Reverse Button