Singer SE9150 - To Hoop the Fabric; Slide On;Off the Hoop

A
B
A
A
B
24 – Embroidery Preparations
To Hoop the Fabric
Slide on/o󰀨 the Hoop
1. Slide the hoop connector into the hoop attachment (A) from
front to back until it clicks into place.
2. To remove the hoop from the embroidery arm, press the
grey button (B) on the hoop attachment and slide the hoop
towards you.
For the best embroidery results, place a layer of stabilizer be-
neath the fabric. When hooping stabilizer and fabric make sure
that they are smooth and securely hooped.
1. Loosen the screw (A) on the larger outer hoop. Remove the
inner hoop. Place the outer hoop on a rm at surface with
the screw on the lower right. There is a small arrow in the
center of the lower edge of the hoop (B) which will line up
with a small arrow on the inner hoop.
2. Place the stabilizer and fabric, with the right sides facing
up, on top of the outer hoop. Place the inner hoop on top of
the fabric with the small arrow at the bottom edge. If you
can see the hoop size in the lower part of the inner hoop,
you have attached it correctly.
3. Push the inner hoop rmly into the outer hoop.
4. Tighten the hoop screw (A). The fabric should be taut in the
hoop for the best results.
Note: Be sure to loosen the hoop screw enough for the fabric
and stabilizer thickness so you can easily push the inner hoop
in place. Push in on the sides of the inner hoop to be sure both
hoops are even.