© Jan. 2024
6 0608ME All Maintenance Manual
MAINTENANCE SAFETY PRECAUTIONS
4. Lock the wheels once the machine is parked to pre-
vent it from moving inadvertently.
5. Do not perform inspection and/or maintenance work
after the machine has been started.
• Before performing inspection and/or mainte-
nance work, make sure the machine is turned
off, and remove the key. An “Out of Service”
warning sign can be placed next to the ground
controls and platform controls, or the main
power switch can be pressed to prevent unre-
lated personnel from inadvertently starting the
machine.
Inadvertently starting the machine during
inspection or maintenance may cause ma-
chine damage and/or personal injury.
• If inspection or maintenance work must be car-
ried out while the machine is running at least two
people should work together. One person must
be close to the turntable control panel or plat-
form control panel so as to be able to turn off the
machine any time if necessary while a second
person carries out inspection or maintenance
work, both persons shall maintain close contact
with each other at all times.
6. Before carrying out maintenance work on electrical
components always press (shut off) the main power
switch.
7. The machine should be cleaned before carrying out
inspection and/or maintenance work. Avoid letting
dust or debris enter internal machine components
during the maintenance process, as this can affect
the machine's performance.
The above listed requirements must be adhered to
strictly during maintenance/inspection work. In addition,
all other appropriate measures must be taken to ensure
safety during maintenance work, taking account of the
working environment.
2.3 MAINTENANCE SAFETY
To Next Page
Loading...
