Sinoboom 0608ME - Function Speed

TECHNICAL CHARACTERISTICS
0608ME All Maintenance Manual 13
© Jan. 2024
Table 3-1 (continued)
Item Metric
Imperial
Maximum allowable altitude 1000 m 3280 ft
Allowable ambient temperature range (lead-
acid battery)
-10° C to 40° C 14℉～104℉
Maximum allowable relative humidity
90 %
Storage environment
Store at -20℃ to 50℃ (-4℉ to 122℉) in a well-ventilated
environment with 90% relative humidity (max.) (20℃ [68℉]),
protected from rain, sun, corrosive gas, flammable or explosive
materials.
Note:
a) The platform height plus the operator height (assumed to be 2 m/6 ft 7 in) equals the working height.
b) In different areas, lubricants should be added in accordance with the ambient temperature.
c) In cold weather, auxiliary devices are needed to start the machine.
d) The ground bearing data is approximate, without considering different options, thus it is applicable only when
taking an adequate safety factor into account.
e) Rated platform load capacity refers to the maximum allowable load on the platform, including the weight of
persons, materials, tools, accessories and other objects.
f) It is recommended not to use lead-acid batteries in ambient temperatures below 0° C, otherwise the battery
capacity will decay rapidly and the battery life will be reduced.
3.2 FUNCTION SPEED
Table 3-2
Item Parameter
Raise the platform
25～30 s
Lower the platform
25～30 s
Travel in high gear – stowed
24.5～30 s
Travel in low gear – stowed
49～60 s
Travel – operating
195～237 s
Braking distance
S≤0.4 m
(1.31 ft)
a) The function speed depends on the start and end
point of the movement rather than the controls/
switches.
b) The drive speed test results will vary with tires of
different specifications.
c) All speed tests should be conducted from the
platform controller. Test results will differ if tested
from the ground controller.
Test requirements:
Raise the platform: With the platform unloaded, raise
the platform (with the scissor arms from fully retracted
position to fully raised position). Perform this maneuver
for two times.
Lower the platform: With the platform unloaded, lower
the platform (with the scissor arms from fully raised posi-
tion to fully retracted position). Perform this maneuver
for two times.
Travel in high gear – stowed: With the machine
stowed on a level surface, switch to high gear, and push
the travel joystick to the maximum travel distance to
drive the machine forward and reverse for 30 m (98.4 ft)
respectively for two times.
Travel in low gear – stowed: With the machine stowed
on a level surface, switch to low gear, and push the trav-
el joystick to the maximum travel distance to drive the
machine forward and reverse for 30 m (98.4 ft) respec-
tively for two times.
Travel – operating: With the machine operating on a
level surface, push the drive joystick to the maximum
forward position to drive the machine forward and re-
verse for 30 m (98.4 ft) respectively for two times.
Braking distance : As described in the “travel in high
gear – stowed” test requirements, once the machine
reaches the maximum drive speed, immediately release
the control handle (starting timing) until the machine
stops. Perform this maneuver for two times.
Note: For Japan models, the machine cannot travel
while elevated to operating position.